Get in Touch Grayslake!
Book a chimney sweep or inspection in Grayslake by calling 847-994-4388, emailing [email protected], or sending the form below. Tell us if the fireplace has an insert or a gas log set — it changes what we bring.
Grayslake began as a railroad village on the Wisconsin Central line beside Gray’s Lake, and most of its growth came much later, as subdivisions filled in around the old downtown from the 1970s on. The result is a small core of older brick and frame houses surrounded by newer neighborhoods. We serve Grayslake from our shop in Buffalo Grove.
Contact Info
We’re here to assist you during our office hours from Monday to Friday, 8am – 5pm. Feel free to call us at 847-994-4388 for any chimney-related inquiries or assistance you may need. Your safety and satisfaction are important to us!
Chimney Sweep in Grayslake: An Old Downtown and Newer Neighborhoods
Our job-photo records hold 24 documented Grayslake projects. Near the old downtown we see brick chimneys with clay flues and the wear that comes with age; in the newer subdivisions most fireplaces are factory-built, with metal chimney pipe inside a sided chase. We also install and service wood-burning inserts and gas log sets here. Call 847-994-4388 or book online.
Older Brick Chimneys
On older Grayslake chimneys the damage usually starts at the top: spalling brick where water has soaked in and frozen, a crown with cracks running across it, and flashing that has pulled away from the brick. Inside, the smoke chamber above the damper is often rough and gapped, which lets heat and creosote reach places they should not. We document all of it on the first visit and put it in order of urgency.
Inserts and Liners
A wood-burning insert turns an open fireplace into a much more efficient heater, but it needs its own stainless liner running the full height of the chimney. Without one, the exhaust cools in the oversized masonry flue and leaves creosote fast. When we install or inspect an insert, we check the liner connection, the top plate and the cap together.
Factory-Built Fireplaces
A factory-built fireplace is a metal firebox and a metal chimney pipe inside a wood-framed chase, tested and listed as one system. Repairs have to use parts that match the listing. Cracked refractory panels and worn dampers are routine; a separated chimney section, or a firebox that can no longer be repaired with listed parts, means the fireplace should not be used until it is corrected. On top of the chase, a steel chase cover that has rusted through lets water run down inside the framing — one of the most common things we photograph. We will tell you which case you are in before you spend anything.
Crowns, Caps and Flashing
Whatever the age of the building, water does most of the damage. A cracked crown lets water into the top of the chimney, and each freeze pushes more of the brick face off. A missing cap lets in rain and animals. Flashing that was patched with sealant during a re-roof fails again within a few seasons. We photograph the crown, the top joints, the flashing and the cap on every visit and treat them as one water system, because fixing one while the others leak only moves the problem.
What We Do Most Often in Grayslake
- Chimney sweep with a Level 1 inspection for masonry fireplaces, factory-built wood-burning fireplaces and stoves.
- Wood-burning inserts and stainless chimney liners.
- Level 2 camera inspections before a sale and after an appliance change.
- Rusted chase cover replacement on factory-built chases.
- Crowns, caps, flashing and spalling brick.
- Gas fireplace, gas log and direct-vent service by NFI-certified technicians.
Our Work in Grayslake
Chimney Monkey has served Grayslake since 2017. The photos below come straight from our own job records — 24 documented Grayslake projects, and more we didn't photograph. Each caption lists the work and the street. We don't publish house numbers.
Chimney Caps & Chase Covers
Stainless caps, chase covers and cap-and-crown work on Grayslake chimneys of every age.



Chimney Crowns
A sound crown sheds water away from the brick instead of into it. New crowns, crown repairs and new clay pots.
Masonry Repair & Chimney Rebuilds
Brick and stone chimneys across Grayslake — rebuilds above the roofline, tuckpointing and masonry repairs.




Flashing
Many "roof leaks" near a chimney are flashing failures. New step and counter flashing where the old work had failed.
Factory-Built Chimneys & Direct-Vent Terminations
Metal chimney pipe, chases, caps and vent terminations for factory-built and direct-vent fireplaces in Grayslake.



Chimney Liners
Stainless liners for fireplaces, furnaces and water heaters — the part of the chimney you never see, and the one that matters most for safety.
Fireplaces, Inserts & Gas Logs
Gas fireplaces, inserts, gas log sets and fireplace sweeps in Grayslake living rooms and family rooms.
Before the Repair: What We Find in Grayslake
Cracked crowns, spalling brick, rusted chase covers, nests and failing flue tiles. These are the conditions our inspections catch — usually before they become a leak or a safety problem inside the house.









Areas We Cover
All of Grayslake, from the blocks around the old downtown and Center Street to the newer subdivisions along Route 83, Route 120 and Washington Street. We also work in neighboring Gurnee, Libertyville and Mundelein.
Why Our Inspections Are Paid
We charge for inspections because the inspection is the service: we document what is actually happening with photographs and, where conditions allow, video of the inside of the flue, then explain what is urgent, what is maintenance and what can reasonably wait. A quote prices a job you already know you need. A diagnostic inspection determines what the job actually is. The report is yours whether or not we do the repair.
Who You Are Hiring
Chimney Monkey has been in business since 2017 and works out of Buffalo Grove. We are members and sponsors of the National Chimney Sweep Guild — our partner Brett Conklin serves on the NCSG board as an at-large director through 2027 — and we belong to the regional North Central Chimney Guild. Our technicians are NFI certified across wood-burning, gas and pellet appliances, we have SPRAT-certified technicians for rope-access work, and our crew trains through the year. One of our three partners is a U.S. military veteran. More than 1,100 Google reviews.
Our repairs and installations carry the Chimney Monkey Workmanship Warranty: 2 years on workmanship and materials, 3 years on venting and appliance systems, 12 years on structural masonry and liner installations — one step past the 1-2-10 residential standard, kept in force by an annual inspection.
Grayslake Chimney Questions
How much does a chimney sweep cost in Grayslake?
As of November 2026, a chimney sweep in Grayslake is $335 to $350 and includes the Level 1 inspection, for masonry and factory-built wood-burning fireplaces alike. An inspection on its own is $205 to $300, and the same rate covers a utility chimney serving a furnace or water heater. A Level 2 inspection with video of the flue is around $300.
Can we put a wood-burning insert in our existing fireplace?
Often, yes, if the firebox and chimney are sound. The insert needs a stainless liner the full height of the chimney. We inspect first, because the condition of the chimney decides whether the insert is a good idea.
Our fireplace is factory-built. Does it need sweeping?
If it burns wood, yes: creosote builds up in the metal chimney pipe just as it does in a masonry flue. A gas-only direct-vent fireplace does not need sweeping, but it does need an annual inspection and service.
Do you charge for the inspection?
Yes. You are paying for a documented answer: photographs, video of the flue where conditions allow, and a written explanation of what needs correcting now and what can wait. The report is yours whether or not we do the repair.
Our Prices
Typical rates as of November 2026. A chimney sweep in Grayslake is $335 to $350 with the Level 1 inspection included, for masonry and factory-built wood-burning fireplaces alike. An inspection on its own is $205 to $300, and the same rate covers a utility chimney serving a furnace or water heater. A Level 2 inspection with video of the flue is around $300. Crown replacement on a masonry chimney typically runs $850 to $2,600, depending on its size. Liners, chase covers, refractory panels and masonry are quoted in writing after the inspection, because pricing an unknown condition is guessing. The full list is on our chimney service costs page. Call 847-994-4388 to book or to confirm current pricing.





